CO2 Monitor (MH9-CO2)

From eedomus - Documentation

Jump to: navigation, search


MCO Home website : http://www.mcohome.com


TYPE DEVICE EEDOMUS
PARAMETERS
COMMENT DOCUMENTATION

CO2 sensor / Z-Wave / MCO Home

CO2 Monitor (MH9-CO2)

Include/Exclude: Activate Inclusion/Exclusion mode on the controller. When device is powered on, long press K2 can enter interface for inclusion or exclusion of Z-Wave network.
* If device has not been included into any Z-Wave network before, “- - -”will display on the screen.
* Then press K2 once, “- - -” flashing and device enters into learning mode to get a node ID. If inclusion is success, a node ID will display on the screen. If not, “- - -” will stop flashing in 20 sec.
* If a node ID displays, it means the device is already in a Z-Wave network. To press K2 once can remove it from the network. “- - -” displays and press K1 once can return to normal work.
Default Z-Wave group for the eedomus controller: 2
Batteries: Alimentation 12V ou USB



Data in Z-Wave: CO2, Temperature, Humidity

20160531160808.pdf