PM2.5 Monitor (MH10-PM2.5)

CO2 sensor / Z-Wave / MCO Home

PM2.5 Monitor (MH10-PM2.5)

Include/Exclude: Activate Inclusion/Exclusion mode in the gateway. When device powered on, long press S1 & S3 synchronically to enter interface for inclusion or exclusion of Z-Wave network.
* If device has not been included into any Z-Wave network before, "- - -" will display on the screen.
* Then press S1 once, "- - -" flashing and device enters into learning mode to get a node ID. If inclusion is success, a node ID will display on the screen. If not, "- - -" will stop flashing in 20
sec.
* If a node ID displays, it means the device is already in a Z-Wave network. To press S1 once can remove it from the network. "- - -" displays and press S2 once can return to normal work.
Default Z-Wave group for the eedomus controller: 2
Batteries: Alimentation 12V

Data in Z-Wave: PPM, Temperature, Humidity