RemSwiid (SW-ZRC1)

From eedomus - Documentation

Jump to: navigation, search


Swiidlifx website : http://www.swiid.com


TYPE DEVICE EEDOMUS
PARAMETERS
COMMENT DOCUMENTATION

Remote / Z-Wave / Swiidlifx

RemSwiid (SW-ZRC1)

Include/Exclude: Press and hold both the "Up" and "Down" command keys of the remote until the blue Z-Wave LED lights up (after 2-3 seconds) and stays lit indicating the remote is in the Setup Mode. Press once on the "All" key and the both the green and red LEDs will also light up to indicate that the inclusion process can begin. The 3 LEDs will then blink rapidly and turn off to indicate that the process has completed successfully. If not successful, the LEDs will remain lit solid until they time out after 30 seconds.
Default Z-Wave group for the eedomus controller: 1
Batteries: 2x AA (1,5V)





ZRC1 Users manual v1.08.pdf
ZRC1-AS.pdf